 | Programmable Features By Personal Computer Or At Factory
 | Call Sign
 | Up to 50 character call sign, "-" and "/" |
| Call sign proceeded by DE (from) for repeaters |
|
| Operation Modes
| 1 Identifies after each time period |
| 2 Identifies after each transmission |
| 3 Identifies one time period after beginning of a transmission |
| 4 Identifies at the beginning of a transmission and again one time
period after its beginning |
|
| Monitor Release Delay Timer:
| 3 seconds, programmable from 0-19 seconds |
|
| Interval Timer (time period):
| 15 Minutes, programmable 0-63 minutes |
|
| Morse Code Speed:
| 24 Word/Minute, programmable 10 to 40 |
|
| Tone Frequency:
| 1080 Hz, programmable 690 to 2000 Hz |
|
|
| Monitor Inputs
| Receiver (Rx) COR Monitor
| Switch set to active low or active high |
|
| Transmitter (Tx) Keying Monitor
| Active low. Usually controlled by push to talk closure. This
terminal starts interval timer in modes 3 & 4 |
|
| RX And TX Monitor Loading
| 1 mA max, at 0 VDC, 0 mA when above +5 VDC |
|
| RX And TX Monitor Levels
| Digital low = 0 to +1.2 VDC |
| Digital hi = +3.5 to +75 VDC |
|
|
| Audio Output
| 1000 ohm +/- 20% impedance |
| Four level sine wave |
| Output Noise, 30db below rated output |
| Output Level, variable from -25 to -3 DBM |
|
| Test switch, transmit indicator |
| Options Available
| RS232 PC programming cable and software |
| 120 VAC wall transformer |
| Factory programming |
| Toneless CW pulsed carrier ID |
|
| Operates on 8-16 VDC/VAC 100 mA |
| Size: 3.3" wide x 2.4" high x 1.2" deep |
| All features and operation modes comply with FCC regulations
|
