1402 - Specs

MODEL 1214V - Specifications

Call Sign, Station, Transmitter and Voice Identification

	User recorded in voice up to 60 seconds in length
	60 seconds of digital audio
	Recorded with a built-in microphone
	Audio message retained without power or batteries

Programmable Features Set By On-board Switches

Operation Modes

	1 Identifies after each time period
	2 Identifies after each transmission
	3 Identifies one time period after beginning of a transmission
	4 Identifies at the beginning of a transmission and again one time period after its beginning

Monitor Release Delay Timer:

3 seconds, programmable from 0-19 seconds

Interval Timer (time period):

	15 Minutes, programmable 0-20 minutes
	Longer times available on special order

Monitor Inputs

Receiver (Rx) COR Monitor

Switch set to active low or active high

Transmitter (Tx) Keying Monitor

Active low. Usually controlled by push to talk closure. This terminal starts interval timer in modes 3 & 4

RX And TX Monitor Loading

1 mA max, at 0 VDC, 0 mA when above +5 VDC

RX And TX Monitor Levels

	Digital low = 0 to +1.2 VDC
	Digital hi = +3.5 to +75 VDC

Audio activity monitor

Audio Output

	600 ohm unbalanced audio output
	Signwave distortion, max 20%
	Output Noise, 50db below rated output
	Output Level, variable from -25 to -3 DBM

Test switch, transmit indicator and speaker

Normally open and closed relay contacts

Options Available

	120 VAC wall transformer
	19 inch rack mount panel
	Custom values for timers and delays

Operates on 8-25 VDC/VAC 200 mA

Size: 8.5" wide x 1.75" high x 5.5" deep

All features and operation modes comply with FCC regulations